Customize Consent Preferences

We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.

The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ... 

Always Active

Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.

No cookies to display.

Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.

No cookies to display.

Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.

No cookies to display.

Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.

No cookies to display.

Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.

No cookies to display.

3d nyomtató építés – 8

Sajnos a faxból kibányászott motorok nem váltak be, csupán a menetesszár súlya elég volt hozzá, hogy forgás helyett csak remegjenek. 🙁 Az alaplapom és a tápegységem 12 voltos, ezek a motorok meg 24 voltosak, ráadásul a sorba kötött tekercsek miatt az ellenállásuk összeadódik, az 320 ohm, majdnem kétszázszorosa a NEMA 17-ének; csoda, hogy „üresen” forogtak.

Ideiglenes megoldásként egy menetesszáras megoldással fogok kísérletezni: elég-e a jól csapágyazott z-tengelyt az egyik oldalon emelni/süllyeszteni? Vagy ha nem, akkor középen megoldható-e az emelés? Ez utóbbi esetben a motor saját magát is emelné, és a menetesszár felül kiemelkedne a nyomtató fölé, ami fura lenne, de „ha hülyén néz ki de működik akkor nem hülyeség”. 🙂

A NEMA 17-es motort elvileg ma hozza a GLS, a lineáris tengelyt és a csapágyait sajnos csak a jövőhéten, a nyomtatófej fűtőblokkját meg már 26 napja feladták Kínában, de még pont két hetet jósolnak a megérkezéséig. 🙁

Vélemény, hozzászólás?